XY Stages

The XY stage is suitable for long travel distances and is primarily used for measuring applications.

High loads with long travels

The KT470 XY stage with DC-Motor is used in metrology and surface inspection. Low run-off with regard to straightness and flatness can be achieved by using cross rollers. This leads to an above-average repeatability, which is the basis for good compensation. This enables an extremely high accuracy for measuring applications.


  • very high resolution up to 0.1 µm
  • Positioning of loads up to 230 N with an economical drive
  • high speeds up to 100 mm/s
  • Reduction of random errors to a minimum
  • very high reliability with minimal frictional resistance
    the use of lapped cross roller bearings



Cost-optimized and reliable positioning

Depending on customer requirements, the XY system is equipped with a stepper motor or DC motor. The DC motor is the first choice for applications with high speeds and low torques. If, on the other hand, the positioning task requires low power and low speeds, the stepper motor is the appropriate variant. The recommended load in the precision cycle is 10 kg, the maximum load is 30 kg.

Modell KT470-DC-300-DC-L-300-DC-R
Travel [mm] 300300
Repeatability unidirectional [μm]± 0.5± 3
Repeatability bidirectional [μm]± 0.7± 4
Accuracy [μm]± 3.6± 19.7
Flatness [μm]± 7.5± 7.5
Straightness [μm]± 3± 3
Positioning speed [mm/s]5050
Max. speed [mm/s]100100
Max. acceleration [m/s2]11
Max. load Fx [N]4545
Max. load Fy [N]4545
Max. load Fz [N]230230
Max. torque Mx [Nm]1111
Max. torque My [Nm]1111
Max. torque Mz [Nm]1010
Pitch [µrad]± 170± 170
Yaw [µrad]± 85± 85
Resolution [μm]0.11
Subject to change. Values ​​apply to single axes with our controllers.

    1. Your customized system

    1. Your contact details
    1. *lease read our data protection regulations here before sending the contact form.

Are you looking for the best technical solution? Get in touch with us:

Nadine Strudel

+49 151 16755992