KT470-SM
XY Stages

XY Stage with stepper motor for the inspection of surfaces and large travel distances.
KT470-SM

High loads with long travels

The KT470 XY stage with stepper motor is used in metrology and surface inspection. Low run-off with regard to straightness and flatness can be achieved by using cross rollers. This leads to an above-average repeatability, which is the basis for good compensation. This enables an extremely high accuracy for measuring applications.

 

  • very high resolution up to 0.625 µm
  • Positioning of loads up to 230 N with an economical drive
  • high speeds up to 40 mm/s
  • Reduction of random errors to a minimum
  • very high reliability with minimal frictional resistance
    the use of lapped cross roller bearings

 

Cost-optimized and reliable positioning

Depending on customer requirements, the XY system is equipped with a stepper motor or DC motor. The DC motor is the first choice for applications with high speeds and low torques. If, on the other hand, the positioning task requires low power and low speeds, the stepper motor is the appropriate variant. The recommended load in the precision cycle is 10 kg, the maximum load is 30 kg.

Modell KT470-SM-300-SM
Travel [mm] 300
Repeatability unidirectional [μm]± 2.3
Repeatability bidirectional [μm]± 3.3
Accuracy [μm]± 18.9
Flatness [μm]± 7.5
Straightness [μm]± 3
Positioning speed [mm/s]20
Max. speed [mm/s]40
Max. acceleration [m/s2]0.4
Max. load Fx [N]45
Max. load Fy [N]45
Max. load Fz [N]230
Max. torque Mx [Nm]11
Max. torque My [Nm]11
Max. torque Mz [Nm]10
Pitch [µrad]± 170
Yaw [µrad]± 85
Resolution [μm]0.625
Subject to change. Values ​​apply to single axes with our controllers.


    1. Your customized system



    1. Your contact details
    1. *lease read our data protection regulations here before sending the contact form.

Are you looking for the best technical solution? Get in touch with us:

Nadine Strudel
Sales
International

+49 151 16755992
E-mail